Please take some time to read the following advice to get the best results.

1) Wipe away any dust or oil from the location where the material is to be applied. Rubbing alcohol or glass cleaner can be used. Horizontal and vertically placed masking tape can be used as a guide to positioning the sticker.

2) Peel the paper backing away from the application tape making sure all the sticker has been transferred to the tape. Be careful not to allow it to touch anything as once stuck can be hard to remove.

3) Place the entire piece of application tape against the object then press down evenly on the tape, working from top to bottom towards the edges. While constantly making sure the material has been transferred to the object.

Large Stickers
A fine mist of water can be sprayed prior to sticking but make sure it is fully dry before removing the backing. This can be very handy if sticking large areas as it allows removal of the sticker to re-place. The water can be squeegeed out with a bank card and dried with paper towels.

When transferring the material to the object, air may get between the material and the transfer surface, forming air bubbles. If this happens, use a needle to puncture the bubbles, then press out the trapped air and affix the material to the transfer surface.

Please note that once the vinyl has been stuck down it can not be re-positioned so take care that you have lined it up!

4) Slowly peel away the application tape making sure that all the vinyl has stuck to the surface...keep your hand close to the surface as you peel.